If I create a perfectly straight Polyline, Capture v5 refuses to copy it. It gives me the following: Failed to run command 'Copy'. Exception: Parameter is not valid"
But if I slightly bend the line, it'll copy it just fine.
Has this happened to anyone else?
Running Capture v5 on Windows XP, SP3.
Can't copy straight Polylines
-
- Jr. Propeller Head
- Posts: 2
- Joined: Wed Oct 23, 2013 11:49 am
Re: Can't copy straight Polylines
I am using Capture 6 and cannot copy a polyline. I get the same error message about a failed operation.
I see the original post was from 2011. Anyone successfully done this since then?
Linda
I see the original post was from 2011. Anyone successfully done this since then?
Linda
-
- Sr. Propeller Head
- Posts: 308
- Joined: Tue Jun 18, 2013 3:00 am
- Location: Eastern Seaboard, Thailand
- Contact:
Re: Can't copy straight Polylines
I am using v6.0.2, and I am able to copy a straight polyline - no error.
As a workaround, can you add the polyline to a palette?
As a workaround, can you add the polyline to a palette?
Tom
Flare 2022, Capture 7
Flare 2022, Capture 7
-
- Sr. Propeller Head
- Posts: 344
- Joined: Thu Feb 09, 2006 1:22 am
- Location: Netherlands
- Contact:
Re: Can't copy straight Polylines
I have also no problems with copying polylines. In the past it was a problem.
Wil Veenstra
Documentation and Training Centre
Infologic Nederland
(Using Flare 11.1.2, Capture 7.0.0 and Mimic 7.0.0 in Windows 10 64-bit)
Documentation and Training Centre
Infologic Nederland
(Using Flare 11.1.2, Capture 7.0.0 and Mimic 7.0.0 in Windows 10 64-bit)
-
- Senior Propellus Maximus
- Posts: 2089
- Joined: Tue Mar 07, 2006 5:06 pm
- Location: Adelaide, far side of the world ( 34°56'0.78\"S 138°46'44.28\"E).
- Contact:
Re: Can't copy straight Polylines
I'm using Capure 6 and copying polylines is not a problem.
For example, I create a black arrow on my image. If I want to copy the polyline I can by right clicking the polyline, making it turn yellow. It can be copied and pasted...
HTH
For example, I create a black arrow on my image. If I want to copy the polyline I can by right clicking the polyline, making it turn yellow. It can be copied and pasted...
HTH
Steve
Life's too short for bad coffee, bad chocolate, and bad red wine.