I'm using v6 of Capture. I need to remove the watermarks left by the trial version.
There does not seem to be a Regenerate option in version 6.
Remove watermark from trial version (Capture v6)
-
- Senior Propellus Maximus
- Posts: 2089
- Joined: Tue Mar 07, 2006 5:06 pm
- Location: Adelaide, far side of the world ( 34°56'0.78\"S 138°46'44.28\"E).
- Contact:
Re: Remove watermark from trial version (Capture v6)
Have you tried a 'save as' to see if that updates the images?
Steve
Life's too short for bad coffee, bad chocolate, and bad red wine.
Re: Remove watermark from trial version (Capture v6)
I just happen to have read about this this morning as I was looking for something else.
To get rid of the watermark, you want to remove the profile from all the images (i assume the profile contains the watermark).
To do this, follow this procedure: http://webhelp.madcapsoftware.com/captu ... Images.htm
In particular, see the section 'How to apply a profile to many images in a batch' and in that section, point 6. It makes a specific reference to removing the trial-mode watermark.
"This option is useful if you are a newly registered user and want to remove the trial-mode watermarks on all of your images."
Essentially, you want to apply a 'no profile' profile to many images in a batch.
Hope that's what you were after..
Avril
To get rid of the watermark, you want to remove the profile from all the images (i assume the profile contains the watermark).
To do this, follow this procedure: http://webhelp.madcapsoftware.com/captu ... Images.htm
In particular, see the section 'How to apply a profile to many images in a batch' and in that section, point 6. It makes a specific reference to removing the trial-mode watermark.
"This option is useful if you are a newly registered user and want to remove the trial-mode watermarks on all of your images."
Essentially, you want to apply a 'no profile' profile to many images in a batch.
Hope that's what you were after..
Avril