Flare 12 "Retrieving source control status" (git) hangs

[skwpt]

I came to the office ridiculously early today to make headway on a deadline. When I tried to open my project, The "Retrieving source control status" window processed for around 25 minutes until I finally just closed it.

Has anyone else seen this behavior? Its the first time I have seen it since successfully binding to Git in Flare 12 about a week ago.

[Nita Beck]

Just a guess... Was the remote Git server down? If you temporarily disconnect from your network and then start up the project, does the project load then? That might point to the remote server being down and Flare just keeps trying to ping it. I repeat, just a guess...

[skwpt]

Just a guess... Was the remote Git server down?

I did wonder about that. After I closed the "Retrieving..." message and did some stuff in Flare, I successfully pushed the changes to the remote repos. At least I assume I did. That dialog always goes by too fast, and I haven't yet discovered any git logs.

If it happens again, I will disconnect from the network and see how Flare behaves, thanks.

[M_Mercer2015]

I started experiencing this with Flare 12 too. It takes forever and then eventually works. I don't recall having this problem with Flare 11.

Update: It wasn't our server. It appears to have been our virus software. The next time it happens this will be the first thing I check.

[kgmarie]

Mine does this as well with Subversion. Haven't been able to find out how to fix it yet...

[kirinawust]

8 years ago ... Did you find a solution?
I am having the same problem with Flare 2023 r2.

Thx in advance