Linking between multiple targets/outputs
Posted: Thu Jun 01, 2017 12:45 pm
Hi all, completely new here, new to Madcap, and I have a very short time to generate a fairly robust single source prototype
Basically my project:
I have a set of subsystems which sometimes contain the same equipment but with slightly different troubleshooting procedures and variables. I've figured out how to use conditional tags and multiple targets to get the job done; however, I'm at a loss for linking them all together from the home/landing page. I can see how I could manually generate a landing page in the output folder that links into each of the outputs, but is there not some way to generate that landing page and link it up to each of the outputs inside Flare? And would the search continue to search through all outputs?
So in short, viewing the primary would take you to a landing page and from the landing page you'd be able to navigate to the other outputs (and the search would search all outputs... not sure if that's possible or not).
I tried to do the linking in the TOCs but trying to link between project targets just removes my TOC entry in the output... not sure what that's about.
Would appreciate any help!
Thanks in advance!
Basically my project:
I have a set of subsystems which sometimes contain the same equipment but with slightly different troubleshooting procedures and variables. I've figured out how to use conditional tags and multiple targets to get the job done; however, I'm at a loss for linking them all together from the home/landing page. I can see how I could manually generate a landing page in the output folder that links into each of the outputs, but is there not some way to generate that landing page and link it up to each of the outputs inside Flare? And would the search continue to search through all outputs?
So in short, viewing the primary would take you to a landing page and from the landing page you'd be able to navigate to the other outputs (and the search would search all outputs... not sure if that's possible or not).
I tried to do the linking in the TOCs but trying to link between project targets just removes my TOC entry in the output... not sure what that's about.
Would appreciate any help!
Thanks in advance!