Imagine you have a vertical image of a lift (or elevator) buttons. It is approximately 1 inch wide and 3.75 inches tall, and 9 buttons.
I want to image on the left side of the page, with the text to the right of each button.
The only way I have been able to do this, is by creating a 2 column, 1 line table. However a table is not ideal for blind people who use screen readers.
I seem unable to find any way to change the properties of the image. I can have text above and below, etc., but not to the left or right.
Where stupid mistake(s) am I making?
Text to right of image
-
- Sr. Propeller Head
- Posts: 193
- Joined: Fri Dec 09, 2005 9:23 pm
- Location: NORTHAMPTON, England, UK
- Contact:
Text to right of image
George Bell
Techno-Vision Systems Ltd., U.K.
Techno-Vision Systems Ltd., U.K.
-
- Senior Propellus Maximus
- Posts: 2089
- Joined: Tue Mar 07, 2006 5:06 pm
- Location: Adelaide, far side of the world ( 34°56'0.78\"S 138°46'44.28\"E).
- Contact:
Re: Text to right of image
Have you tried {float: left;} ?
Steve
Life's too short for bad coffee, bad chocolate, and bad red wine.
-
- Sr. Propeller Head
- Posts: 193
- Joined: Fri Dec 09, 2005 9:23 pm
- Location: NORTHAMPTON, England, UK
- Contact:
Re: Text to right of image
Many thanks for the quick reply.
I will be quite honest, being far from a coder, I normally only go to the editor for very simple corrections. Otherwise it's the WYSIWYG editor.
Since it is possible to deal with text and image vertically, I felt sure I was missing a similar feature for horizontal positioning.
I will be quite honest, being far from a coder, I normally only go to the editor for very simple corrections. Otherwise it's the WYSIWYG editor.
Since it is possible to deal with text and image vertically, I felt sure I was missing a similar feature for horizontal positioning.
George Bell
Techno-Vision Systems Ltd., U.K.
Techno-Vision Systems Ltd., U.K.
-
- Sr. Propeller Head
- Posts: 248
- Joined: Thu May 24, 2018 3:11 pm
- Location: Queensland, Australia
Re: Text to right of image
Float left is available from the wysiwyg editor:
Cheers,
Rob
- Insert an image
- Type your text
- Right click the image and choose Image Properties > Position, then choose Float Left on the image.
- The text will jump to the right of the image.
Cheers,
Rob