Shouldn't I be able to create a target for Word using Master Pages and a target for PDF using page layouts and two TOCs each using either the MPs or PLs?
The reason I ask is because when I do this I have a MP cover that seems to pull the PL main page.
master pages and page layouts
-
- Sr. Propeller Head
- Posts: 159
- Joined: Thu Sep 18, 2008 8:34 am
- Location: "West of the Mississippi"
master pages and page layouts
Christy Patton
Technical Communications
MadPak
Flare 6.1
Capture 4.0
Technical Communications
MadPak
Flare 6.1
Capture 4.0
Re: master pages and page layouts
Do you have two different targets and the Word target is set to use the masterpage and the PDF output is set to use the page layout (with masterpages being explicitly disabled)?
Lisa
Eagles may soar, but weasels aren't sucked into jet engines.
Warning! Loose nut behind the keyboard.
-
- Sr. Propeller Head
- Posts: 159
- Joined: Thu Sep 18, 2008 8:34 am
- Location: "West of the Mississippi"
Re: master pages and page layouts
I cannot disable the Master pages, the section where that is done is greyed out. I read another forum on that issue and followed those steps and it is still grey.
Christy Patton
Technical Communications
MadPak
Flare 6.1
Capture 4.0
Technical Communications
MadPak
Flare 6.1
Capture 4.0
Re: master pages and page layouts
Do you have a masterpage in your project?
Lisa
Eagles may soar, but weasels aren't sucked into jet engines.
Warning! Loose nut behind the keyboard.
-
- Sr. Propeller Head
- Posts: 159
- Joined: Thu Sep 18, 2008 8:34 am
- Location: "West of the Mississippi"
Re: master pages and page layouts
I have two different projects. I have had to build one with no master pages and one with no page layouts. I have to be able to go to Word for government contracts and PDF for commercial contracts. When I build with two TOC's and two targets, that is when I have problems.
There have been several issues all at the same time and I have really had a difficult time in separating issues. You might be interested in
http://forums.madcapsoftware.com/viewto ... 807#p48807
I'm waiting on Madcap tech support for a solution here.
There have been several issues all at the same time and I have really had a difficult time in separating issues. You might be interested in
http://forums.madcapsoftware.com/viewto ... 807#p48807
I'm waiting on Madcap tech support for a solution here.
Christy Patton
Technical Communications
MadPak
Flare 6.1
Capture 4.0
Technical Communications
MadPak
Flare 6.1
Capture 4.0