Remove watermark from trial version (Capture v6)

This Forum is for General Issues about Capture
Post Reply
ltam
Jr. Propeller Head
Posts: 6
Joined: Thu Dec 20, 2012 2:39 pm

Remove watermark from trial version (Capture v6)

Post by ltam »

I'm using v6 of Capture. I need to remove the watermarks left by the trial version.

There does not seem to be a Regenerate option in version 6.
SteveS
Senior Propellus Maximus
Posts: 2087
Joined: Tue Mar 07, 2006 5:06 pm
Location: Adelaide, far side of the world ( 34°56'0.78\"S 138°46'44.28\"E).
Contact:

Re: Remove watermark from trial version (Capture v6)

Post by SteveS »

Have you tried a 'save as' to see if that updates the images?
Image
Steve
Life's too short for bad coffee, bad chocolate, and bad red wine.
CATERAF
Sr. Propeller Head
Posts: 103
Joined: Mon Mar 18, 2013 10:19 pm
Location: Perth, Australia

Re: Remove watermark from trial version (Capture v6)

Post by CATERAF »

I just happen to have read about this this morning as I was looking for something else.

To get rid of the watermark, you want to remove the profile from all the images (i assume the profile contains the watermark).

To do this, follow this procedure: http://webhelp.madcapsoftware.com/captu ... Images.htm
In particular, see the section 'How to apply a profile to many images in a batch' and in that section, point 6. It makes a specific reference to removing the trial-mode watermark.
"This option is useful if you are a newly registered user and want to remove the trial-mode watermarks on all of your images."

Essentially, you want to apply a 'no profile' profile to many images in a batch.

Hope that's what you were after..
Avril
Post Reply