Why is it that after building (then viewing) the DotNet output that you can't continue to work in Flare (alt-Tabbing between the two to make any changes which can be done with CHM / PDF outputs)?
Oddly (or not), yes, I can open up said DotNet output separately and continue to work in Flare.
Submission time?
Viewing DotNet and Using Flare?
-
Richard Ferrell
- Propellus Maximus
- Posts: 840
- Joined: Mon May 01, 2006 10:11 am
- Location: Inside California
Re: Viewing DotNet and Using Flare?
When Viewing the Dot Net Help from Flare, it lauches Flare v4.1 Build in Dot Net viewer and not the stand alone viewer, So in order to go back into Flare you have to close this built in viewer.
Richard Ferrell
Certified Madcap Trainer
Certified Madcap Trainer
-
Robotman
- Sr. Propeller Head
- Posts: 186
- Joined: Sat Mar 04, 2006 3:05 am
- Location: Melbourne, Australia
- Contact:
Re: Viewing DotNet and Using Flare?
Thanks Richard. I've submitted it.
Cheers,
Cheers,