Page 1 of 1
how to get rid of the default madcap flare logo
Posted: Mon Mar 02, 2009 6:24 pm
by madcapnewbie
Hi all,
How do you sub in your company logo for the default madcap flare logo - Is this done through the skin?
Re: how to get rid of the default madcap flare logo
Posted: Tue Mar 03, 2009 9:02 am
by nfberg
To change the logo go to the skin and on the Styles tab expand ToolbarItem and select Logo and then Icon.
Re: how to get rid of the default madcap flare logo
Posted: Tue Mar 03, 2009 9:45 am
by doc_guy
You do mean Webhelp output, right? Because as far as I remember, there is a MadCap logo in .NET output that you can't get rid of. But for webHelp, you can swap out MadCap's logo for your logo in the Skin. There is a setting for "logo" and you point to a file.
Re: how to get rid of the default madcap flare logo
Posted: Tue Mar 03, 2009 10:22 am
by madcapnewbie
thanks!
I followed these steps but I can't see my logo - All I see is the logoicon text in the toolbar - does this mean my image is too big?
Re: how to get rid of the default madcap flare logo
Posted: Tue Mar 03, 2009 12:59 pm
by LTinker68
Possibly. You can adjust the toolbar height from the skin, as well, or you can make your logo smaller.
Re: how to get rid of the default madcap flare logo
Posted: Tue Mar 03, 2009 1:31 pm
by doc_guy
I don' believe it will resize your logo for you, so you will need to make the image the correct height before you plug it into the skin.
My logos are about 28px high, but that is how big my frame is, so your mileage may vary.
Re: how to get rid of the default madcap flare logo
Posted: Thu Mar 05, 2009 5:35 am
by i-tietz
what file format does your icon have? bmp? tif? that would explain it, too - browsers need a gif, jpg or png.
The logo also must be part of the project.